Stainless steel centrifugal fan for sugar dust – Zone 22 inside, 2,150 m³/h at 1,250 Pa
Sweet, sticky, Zone 22? We can do that.
In the food industry, sugar is a raw material like any other – as dust, it becomes a challenge. When moist it turns sticky, and finely dispersed in the air it is combustible. A customer of ZENNER Ventilatoren Werke GmbH designed a plant for the food industry with a cyclone through which exactly this kind of sticky, moist sugar dust is conveyed. To the customer's specifications, we designed and built a compact centrifugal fan for it that can be installed on the roof.
The dust defined the requirements: inside, the fan had to comply with ATEX Zone 22; outside, no zone was specified. Zone 22 stands for areas in which an explosive dust atmosphere does not occur in normal operation, or only briefly – rarely, in other words, but possible all the same.
The result is a fairly small fan: 490 mm wide, 700 mm high and 680 mm long, weighing just 75 kg – an advantage for a unit that is to stand on a roof. A directly driven two-pole motor rated at 2.2 kW drives the 315 mm impeller. The fan thus reaches a volume flow of 2,150 m³/h at a pressure of 1,250 Pa.
The fan was made entirely of stainless steel. In the food industry this is the natural choice: stainless steel resists corrosion even when the dust is moist, and it can be cleaned thoroughly.
Roof installation and integration into the plant are ensured by the equipment:
- fan made entirely of stainless steel
- compensator to decouple the fan from the ductwork
- rubber buffers for vibration isolation
- base frame for roof installation
- earthing straps across the compensator and rubber buffers for equipotential bonding
Sticky dust, explosion protection inside and a place on the roof: each of these requirements shaped the design – from the material to the frame the fan stands on.
The only sweet thing here is the medium.
Another example of the fact that a fan is not just a fan.
ZENNER Ventilatoren – Durable. Low-maintenance. Quality since 1947.
Made in Germany.
This version is suitable when:
- sticky or moist dusts such as sugar dust are conveyed, for instance in plants with a cyclone
- ATEX Zone 22 applies inside the fan, but no zone is specified outside
- the food industry or a moist medium calls for a stainless steel fan
- the fan is to stand on a roof and therefore has to be compact and light
- volume flows of around 2,150 m³/h at about 1,250 Pa are needed
- a low-maintenance direct drive without belts is preferred
It is not suitable when:
- an ATEX zone also applies outside – the fan then has to be designed for the outer zone as well
- flammable gases rather than dusts occur (Zone 1 or 2) – this version is built for dust in Zone 22
- large volume flows or high pressures are required – with 2.2 kW the fan is deliberately designed small
- high medium temperatures occur, as covered by a hot-gas fan
- highly abrasive solids are conveyed that require a wear-protected version
- Application: food industry, plant with cyclone
- Medium: sticky, moist sugar dust
- Explosion protection: ATEX Zone 22 inside, no zone specified outside
- Design: centrifugal fan, direct drive
- Volume flow: 2,150 m³/h
- Pressure: 1,250 Pa
- Impeller: 315 mm
- Drive: direct, two-pole motor rated at 2.2 kW
- Material: stainless steel throughout
- Installation: on the roof, base frame with rubber buffers
- Accessories: compensator, rubber buffers, base frame, earthing straps
- Dimensions: 490 mm (W) × 700 mm (H) × 680 mm (L), weight 75 kg
- Manufacturing: made to order in Germany








